...
Remove all wires from the connector by inserting a depinning tool into the highlighted slots below. Apply light pressure to the depinning tool in the opposite direction of the terminal. This will depress the tab on the terminal and allow you to remove the wire from the connector by pulling the wire out of the connector. Make sure you keep the tab depressed while pulling on the wire. Two of the wire terminals have their locking tabs exposed on the outside of the connector. Simply depress these tabs while lightly pulling on the wire. The wires should separate from the connector body with minimal effort.
...
This marks the end of the depinning process & the beginning of the pinning process.
Next familiarize yourself with the terminals on the end of our ignition coil harness. You will find a heatshrink label on each wire with numbers from 1 to 6 circled in red below.
...