Page Comparison

Feed our ignition coil harness into the DME box through the same rubber sheathing as the factory harness.

• Lay the ignition coil harness over the valve cover and bunch the loose wire ends together.

• Gently wrap tape around the loose wire ends to protect the terminals from damage.

• Gently push the harness through the rubber sheathing until the taped end appear inside the DME box. Pull through about 1 foot of the harness.

Familiarize yourself with the terminals on the end of our ignition coil harness. You will find a heatshrink label on each wire with numbers from 1 to 6 circled in red below.