...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Plug the signal controller into the harness as shown below and slide it into one of the empty DME box dividers. |
...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Attached to the fuel injector harness is a brown wire with a ring terminal. This wire needs to be grounded. We recommend the 10mm bolt on the passenger side strut tower. This wire can be fed through a portion of the existing harness sheathing without modifying or cutting the grommets. The DME box sheathing closest to the front of the vehicle can be separated close to the DME box by pulling & twisting the rubber portion away from the hard nylon plastic section. The brown wire with the ring terminal can then be fed from inside the DME box out and grounded to the side of the strut tower. Once complete reinsert the rubber section of the sheathing over the hard nylon section and the brown wire. |
| Tip |
|---|
Lay the harness behind the valve cover and connect fuel injectors. Use included zip-ties to organize harness. This concludes installing the fuel injector harness. |
...