Familiarize yourself with the terminals on the end of our ignition coil harness. You will find a heatshrink label on each wire with numbers from 1 to 6 circled in red below.
The wires must be installed into the correct position or vehicle/engine damage can occur!
Starting with the wire labeled number 1, insert the terminal into the corresponding position (1) in the connector you depinned above (DME ignition coil connector). Continue inserting all wires into their correct positions and recheck your work to ensure the wires have been inserted into the correct positions.
The wires must be installed into the correct position or vehicle/engine damage can occur!
At this point the ignition coil connector can be reinserted into the DME connector housing.